The statically-configured gateway address to use (e.g. The statically-configured broadcast address to use (e.g. The statically-configured netmask to use (e.g. The statically-configured IP address to use (e.g. if 'static', uses the following wired-* settings to configure wired networking If 'dhcp', uses DHCP to configure wired networking. If 'yes', enables networking over the wired Ethernet port Wired network configuration (SD card installs only) If 'yes', enables use of gpsd to obtain location Upgrades from older than 3.3.0 on a Pi 1 or Pi Zero will be configured with 'no' during the upgrade. Mode A/C decoding requires additional CPU when enabled. SD card installs only: if 'yes', piaware and dump1090-fa will enable Mode A/C decoding if a client requests it. SD card installs only: for receiver-type 'radarcape', configures the Radarcape host PiAware will connect to for ADS-B data SD card installs only: for receiver-type 'rtlsdr', configures which dongle to use if there is more than one connectedįor receiver-type 'relay' or 'other', configures the host PiAware will connect to for ADS-B dataįor receiver-type 'relay' or 'other', configures the port PiAware will connect to for ADS-B data SD card installs only: for receiver-type 'rtlsdr', configures the dongle PPM correction SD card installs only: for receiver-type 'rtlsdr', configures the dongle gain used PiAware logs in /var/log/piaware.log on your existing install.Ĭonfigures how PiAware attempts to talk to the ADS-B receiver (see below)Ī numeric gain value in dB, or 'max' for AGC 'Site Identifier' on the My ADS-B page or may be found in the If 'no', mlat positions for blocked aircraft are not returnedĪ unique identifier (for example: 12345678-1234-1234-1234-123456789abc)Ĭonfigures the unique identifier of a site this should only be set if attempting to preserve anĮxisting site after a hardware upgrade or reflashing the SD card image the existing feeder-id is labeled If 'yes', mlat positions for blocked aircraft are returned with anonymized TIS-B addresses.

If 'yes', multilateration results are returned to PiAware from FlightAwareĬonfigures which ports/formats multilateration results are returned on If 'yes', multilateration is enabled (also requires that receiver location is set on the FlightAware My ADS-B stats page) If 'yes', manually-initiated updates from the My ADS-B Stats page (on ) are allowed If 'yes', FlightAware-initiated updates are allowed Please see 'Optional Steps for Advanced Setup' for instructions on how to edit the configuration file.

Advanced setup